60105 Control Board with 60030 .22" WC Pressure Switch Mr Heater Compact Furnace

Description

This Circuit Board and Pressure Switch combination for Mr Heater Compact Garage Workshop Ceiling Furnace is the 24 Volt 60105 Ignition Control Circuit Board with the 60030 22"WC Vacuum Pressure Switch and is a replacement component for MHU and HSU series heaters manufactured by Enerco to control the automatic ignition system.
This
Circuit Board and Pressure Switch combination will fits the following models:
Mr Heater, Enerco
MHU45 Series Compact Overhead Furnaces
MHU75
Series Compact Overhead Furnaces
Heatstar, Heat Star
HSU45
Series Overhead Compact Furnaces
HSU75
Series Overhead Compact Furnaces
Warning:
Never service a heater while the unit is plugged in, operating or still hot.
Severe burns and electrical shock can occur.
Always check for gas leaks after replacing any gas related parts or products.
Repairs should only be preformed by a licensed mechanical contractor.
Please Note Return Policy:
This Product is an Original Equipment Manufacturers OEM replacement component from the original manufactures of this component and is an exact fit component for the OEM version with the same quality and performance as the original equipment installed component.
All OEM component parts purchased on eBay are purchased by the buyer with no additional offers being given for technical service or on-site installation support methods.
In the event that an OEM component purchased from our eBay store is found to be defective after installation the customer or installer may send the part back for inspection and testing from Source Accessories Warehouse Inc.
If the returned component is considered to have a construction or design defect S.A.W. Inc will send the original buyer a replacement part at no charge.
Any components, parts or accessories purchased that are “NOT” installed, opened, or used is any may be returned within 14 days under authorized conditions and designated RGA number for a partial refund minus the actual shipping cost incurred by S.A.W. Inc. and up to a 20% restocking fee may apply for inspecting and packaging.
Any incurred return shipping cost will be the sole responsibility of the purchaser and will need to be paid for by the purchaser during the return of the purchased product, any goods returned with freight or postage due charges will be refused and not accepted by S.A.W. Inc
The original freight cost covering the goods shipment to the purchaser is not refundable for any reason as no manufacture warranty covers freight cost.
If a claim for a component that arrived damaged is being made, then the original packaging must not be opened or altered to be able to send the part back for an inspection and exchange.
We highly suggest sending photos as soon as the package is discovered to be damaged.
Parts that have been installed or used in any way will not be accepted for refunds of any type.
Please also note that there can be no returns or refunds given on any electrical or gas components that have be installed or claim to be defective due to liability reasons.
All claimed defective warranty components must be sent in at buyer expense for full inspection before any additional warranty replacement parts will be sent by S.A.W. Inc.
All return items will need to have a Returned Good Authorization RGA number with the shipment being sent back to be accepted for return.
By purchasing any components, parts, or accessories from S.A.W. Inc you agree to the terms and conditions outlines on our returns page