24 holes S5 Silicone Heater Pad 508x508mm 20" For Creality CR-10 S5 3D Printer

Description

Our Manufactuer use
Arlon silicone rubber
substrate imported from the United States and
3M
Adhesive Backing, highest quality. Each heated bed is tested before shipping, Much safer and more reliable than other heatbeds.
Description:
NOTE:
This bed is suitable for both 24 holes and old version 4 holes
S5 aluminum plate use.
(
Caution! Before buying, please check if the 24 hole pattern conforms to that of your build plate. Pattern view from the adhesive side of this heater pad must be same to the front view pattern of your 24 hole build plate.)
This silicone heating pad with 24 pre-made screw holes with dia 12mm
as the picture shows
is designed for creality CR-10 S5 3D printer building plate.
Backing:
3M adhesive backing
Size:
508mmx508mm
With 2 meters NTC 100K 3950 thermistor for temperature Control.
​Voltage: 120V(also can be used for 110V); or 220V
Power consumption: 1300W
Attached with two pieces 2meters length wire
Package:
1pcs Silicone Heatpad with wires
Important Notes:
Please heat only after being mounted onto the plate. Do Not heating without proper heat-sink.
Please feel free to contact us for special discount of large quantity purchase.